Wasp W-600 Guia do Utilizador

W-600 Thermal Label PrinterUser’s Guidefor Wasp Bar Code Technologies®DT/TT Printer

7Quick Setup GuideLoading the Media1. Insert the media roll onto the media supply spindle and move the media guide to the inside.2. Push the head latc

8Quick Setup GuideLoading the Media3. Lead the media through the print head module and under the paper sensor guide.Print HeadModulePaper SensorGuide4

9Quick Setup GuideLoading the Media5. Close the top access door and front access door and then turn on the printer or press “FEED” button if the print

10Performing CalibrationNote: This step is very important and must always be carried out whenever media is being changed. Failure to do so will result

11Chapter 1Operator ControlsOperator ControlsPower Switch - Controls printer powerOn - normal operationOff - the power should be turned off before con

12Chapter 2Resetting the PrinterResetting the Printer to FactoryDefault Settings1. Turn off the printer. Press and hold the CANCEL button.2. Turn on t

13Chapter 3Printer DriverPrinter DriverThe bundled printer driver is compatible with Windows 9x, 2000, ME, XP, andWindows NT.Through this driver you m

14Chapter 4Setting Printer PropertiesSetting Printer PropertiesAfter installing the driver, follow the steps below to modify the printer properties:1.

15Chapter 4Setting Printer Properties (cont.)Media choice (Darkness)Some printing applications require changes to the darkness setting.This settingact

TroubleshootingNormally, when the printer has an error, the “Ready” LED indicator will blink.To understand the problem, please check LEDs first:A. Rea

© Copyright Wasp Technologies 2002.All rights reserved.No part of this publication may be reproduced or transmitted in anyform or by any means without

17Chapter 5TroubleshootingB. Ready and Ribbon LEDs blink alternatelyPossible Solutions Refer to PagesProblemsRibbon empty • Reload ribbon 5-9Ribbon ja

18Chapter 5TroubleshootingD. MiscellaneousThe PC says “Printer Time Out”1. Make sure the communications cable (parallel or serial) is connectedsecurel

19Chapter 6Printer MaintenanceClean the following areas of the printer after 8 rolls of labels have been used. Ineach case, use a cotton swab dampened

20Chapter 7Technical SpecificationsModel W-600 Thermal Transfer PrinterPrint Method Direct Thermal or Thermal TransferResolution 203 DPIPrint Width Up

21Chapter 8Product Support & Warranty InformationWasp W-600 Printer is wa r ranted against defects in wo rkmanship and materi a l sfor a period of

Table of ContentsQuick Setup GuideInspecting the Printer ...1Connection Diagram...

1Quick Setup GuideInspecting the PrinterAfter removing the printer from the packaging material, check the contents ofthe package.The following items s

2Quick Setup GuideConnection DiagramAC Electrical OutletAC Power ConnectorPower JackPower SwitchParallel Cable

3Power SupplyQuick Setup GuideConnecting the PrinterNote: Before setting up the printer you should consider the following:1. Find a flat surface with

4Note:This section is not applicable to Direct Thermal (DT) printing.Quick Setup GuideLoading the RibbonLoading the Ribbon1. Lift top access door and

5Loading the RibbonQuick Setup GuideLoading the RibbonBracketHead LatchRibbonSupplySpindle2. Push the head latch counter-clockwise, then push down the

6Quick Setup GuideLoading the Ribbon4. Attach the edge of the ribbon onto the empty core and wind a few turns.Lead the empty core through print head m